Przeszukaj pomoc

Unikaj oszustw związanych z pomocą.Nigdy nie będziemy prosić Cię o dzwonienie na numer telefonu, wysyłanie SMS-ów ani o udostępnianie danych osobowych. Zgłoś podejrzaną aktywność, korzystając z opcji „Zgłoś nadużycie”.

Więcej informacji

Cardbook - NextCloud 29 : contacts with birthday = forbidden

  • 3 odpowiedzi
  • 0 osób ma ten problem
  • Ostatnia odpowiedź od david

more options

Hello,

I have just migrated to NC 29 (.0.8). Since then, it’s impossible to synchronize a contact if a birthday exists. By deleting the birthday, you can synchronize the contact. I’m using cardbook (97.5) - thunderbird(128.4.3esr - 64 bits), on linux.

What should I do?

Thank you for your suggestions.

Best regards,

Christian

NC 29.0.8 shared hosting : ovhcloud php : 8.2 Base : 10.5.27-MariaDB-deb11-log

Hello, I have just migrated to NC 29 (.0.8). Since then, it’s impossible to synchronize a contact if a birthday exists. By deleting the birthday, you can synchronize the contact. I’m using cardbook (97.5) - thunderbird(128.4.3esr - 64 bits), on linux. What should I do? Thank you for your suggestions. Best regards, Christian NC 29.0.8 shared hosting : ovhcloud php : 8.2 Base : 10.5.27-MariaDB-deb11-log

Wszystkie odpowiedzi (3)

more options

Just a suggestion: does the problem occur when cardbook is disabled?

Pomocne?

more options

Remote notebooks are linked via cardbook. If cardbook is deactivated, it is no longer possible to synchronize with NextCloud.

Carbook does save my changes locally, but it refuses to synchronize these changes for contacts with an encoded birthday.

- If I make a change to a card on cardbook, it only synchronizes if the birthday is empty. - If I make the same change on Nextcloud, the synchronization is accepted whether or not there is an encoded birthday, and I see this change on my cardbook.

Pomocne?

more options

I asked, only because there have been a few posts where users had problems with Cardbook. If this worked with prior version of Cardbook or Thunderbird, reverting would be my suggestion, As it is, when multiple components are interacting, it's quite a challenge to figure it out. I have no other suggestions, and hope you are able to work through this.

Pomocne?

Zadaj pytanie

Aby odpowiadać na posty, musisz zalogować się na swoje konto. Zadaj pytanie, jeśli nie masz jeszcze konta.